Window tints get worn away, no matter if they’re expensive or not, or if they’re purchased from a reputable Davis window tinting company. The appearance of bubbles and discoloration are two of the most obvious indicators that could signal that it is time to change your window tints. Experts typically handle window tint replacement to avoid a mess. If you need to delay the date to replace your tint, you can remove the previously used tints to keep them from blocking your vision.
What are the key things you need?
- Razor Blades
- Dishwashing soap
- Soft cloth
- Spray bottle
- Water
- Glass Cleaner
What to do
If you’ve got all the materials, you can follow these steps.
You can take a small part in the edge of the film
Make use of the razor blade to make a small cut at the corner of your film. Your windows and windshields won’t be scratched as long as the blade isn’t pressed too hard.
Then slowly peel the film off.
Begin by slowly peeling the tint off of the window, starting from the corner you have removed. Make sure to work slow to make sure you get rid of all the window tints in one go. If the film has not been completely removed, you can use a shaver’s blade to lift the edges. Then, you can continue peeling until everything is removed.
Use soapy water to spray on windows
In a spray bottle, mix a little dishwashing soap and water. It doesn’t matter how precise the measurements are. It doesn’t really matter how soapy the mix is. After preparing the mix, apply massive amounts of it on the surfaces you wish to make adhesive.
Allow it to sit and soak.
Let the soapy mixture sit for a few hours before spraying it. This lets the adhesive be softer and easier to proceed to the next step.
Get rid of all remaining adhesives
To remove the adhesive residue of the glass, you will require a shaver. If you are worried about scratching your windows, it is enough to gently scrape them clean and make sure that the glass remains wet enough. If the glass starts to dry, it is advisable to spray a different soapy solution.
Cleanse the windows
After you’ve completely gotten rid of the tint as well as its adhesive residue, be sure to wash your windows. All you require is a glass cleaner along with a soft cloth and a pliable cloth to clean your windows. If you don’t have glass cleaner, you could make use of dishwashing soap-water mix. You should avoid using ammonia-based cleaners. Beware of abrasive cleaners, as they can cause scratches.
It’s easy to get rid of the old tints on your windows. This allows you to put on a fresh tint to your car. To ensure your window tints are smooth and perfect, ensure that you do not scratch them.
If you want to make sure that the replacement of your window tint is done professionally, you can count on tint masters MN service to take care of the job for you. KEPLER Coatings can provide more information.
